Description
The Pioneer SX-838 is a 5OW RMS stereo receiver featuring PLL FM MPX, precision equalizer, switched-turnover tone control and direct-coupled OCL power amp.
Depend on Pioneer to provide the latest electronic advances and the SX-838 stereo receiver is a perfect example.
Its FM tuner offers high sensitivity and excellent rejection characteristics thanks to its front end equipped with a frequency-linear 4-gang variable capacitor and two MOS FETs.
The FM IF section has a 6-stage limiter and phase-linear ceramic filters.
For the FM MPX demodulator, Pioneer uses a new PLL (Phase Lock Loop) circuit with an IC.
The results of these state-of-the-art touches are immediately apparent: FM sensitivity of 1.8uV, better than 80dB FM selectivity, capture ratio of 1.0dB (all IHF) and better than 30dB stereo separation (50 to 10,000Hz).
The Phono equalizer in the SX-838 provides accurate reproduction of all the sounds in any record groove by assuring no more than ± 0.3dB deviation from the RIAA curve.
In terms of power, the unit produces 50W + 50W of continuous RMS power (both channels driven at 8 ohms) with total harmonic distortion of less than 0.3% - remember that this figure is measured and guaranteed over the entire spectrum from 20 to 20,000Hz.
The SX-838 is distinguished from all other receivers in its price range by offering switched-turnover flexibility in its tone control operation, permitting the creation of a variety of tonal characteristics to match your room's acoustics or your mood.
And when it comes to versatility, it reproduces no less than six program sources (AM, FM, Phono 1, Phono 2, Mic and Aux).
It also has two stereo sets of tape deck connections with monitor switching (and deck-to-deck duplication).
A total of three pairs of stereo speaker systems can be connected to the SX-838 (with a front-panel switch to use any one or any two of them at once).
Specifications
Tuning range: FM, MW
Power output: 50 watts per channel into 8Ω (stereo)
Frequency response: 10Hz to 70kHz
Damping factor: 45
Input sensitivity: 2mV (mic), 2.5mV (MM), 150mV (DIN), 150mV (line)
Signal to noise ratio: 65dB (mic), 70dB (MM), 95dB (line)
Output: 150mV (line), 30mV (DIN), 1V (Pre out)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 4 x FET, 4 x IC, 43 x transistors, 24 x diodes
Dimensions: 520 x 175 x 420mm
Weight: 16.2kg
Accessories: FM T-type antenna
Year: 1974
