Koetsu Onyx Phono Cartridge New Old Stock - Late 80’s Koetsu Masterpiece - Sugano Built

GBP£4 380.75

The Koetsu Onyx "Gold Pin" Short Body is a transitional vintage moving-coil phono cartridge produced during the later Yoshiaki Sugano era into the early years under his son, Fumihiko Sugano. It sits chronologically between the rare 1980s "Long Body" originals and the modern "Onyx Platinum" models.

 

Key Identifying Features
 
  • Transitional "Short Body" Dimensions. Unlike the earliest 1980s Onyx cartridges—which feature an elongated, flat-bottomed stone housing—this version uses the more compact stone body geometry that became standard on later Koetsu models. 
  • Gold-Plated Terminal Pins. As noted by collectors on Audiogon, older Koetsu stone-body builds are distinguished by gold-plated output pins, whereas modern Platinum-era units typically use silver/rhodium-toned pins. 
  • Pre-Platinum Motor Assembly. Built before the introduction of the current Platinum magnet system, these units generally utilize samarium cobalt or permendur magnets rather than platinum magnets (unless later factory-rebuilt to Platinum specs). 
  • Serial Number & Mounting Details. Users on Audiogon note that original pre-Platinum builds lack the leading "P" in the serial number found on modern Platinum units and often feature unthreaded mounting ears or aluminum mounting bars rather than modern threaded inserts. 
 
 
General Specifications & Setup
While exact factory spec sheets varied slightly across vintage Sugano builds, Koetsu USA and Koetsu Audio list the following baseline parameters for the Onyx stone-body platform: 
 
  • Cartridge Weight. ~12.0 g to 13.0 g (heavy stone housing requires a medium-to-high mass tonearm of 12–20 g or a heavier counterweight).
  • Recommended Tracking Force. 1.8 g to 2.0 g.
  • Output Voltage. ~0.3 mV to 0.4 mV (low-output moving coil).
  • Recommended Load Impedance. 75 Ω to 500 Ω into an active MC phono stage (or 5 Ω to 40 Ω via a step-up transformer).
  • Cantilever. Boron with a low-compliance suspension (~5 to 6 × 10⁻⁶ cm/dyne). 

this is a New Never mounted/played Koetsu, possibly the only NOS Onyx on the planet

recommed local Pick up so you can inspect it using our microscope (pictured )